Setup

• Run 220 power for Laser, Chiller, and air compressor
• Set up chiller. I believe, and YouTube agrees, that input goes to laser output, and output goes to laser input, emergency wire to laser, connect to power.
• Air compressor connect to laser
• connect laser ground wire
• Setup up computer, connect to the USB cable coming from the laser

That may actually be it? Somehow?

Operation

• Check water cooler level, turn on chiller. It doen't want to operate above 86 or under 50 degrees.
• Turn on Air compressor
• Turn on Laser (there is a switch in the back by the power cord, it should be left on, turn on with the key. If necessary pull up the emergency stop)
• Turn on the computer...