• Create
• Write it up

done - Figure out power done - focus/tune? done - Start up checklist done - Maintenance Schedule done - Other resources...

<img src="/images/first_image.jpg" "First view of the laser!" width="300")

It's footprint is 54" x 67"

On June 23rd there was a facebook post. An 80 watt 4' x 3' laser cutter. I jumped on that!

It is probably 'only' 1200 mm x 900 mm, which pedanticism only …

This is a laser cut grating or grill cover. The holes are 1/2". This is a walnut veneer over an MDF core.

Ed then suggested that I make smaller versions suitable for model boats, and he took them to the model boat club where several were snapped up by …

Apparently I wrote this in 2016.

Lasercut Software

The controls on the right side allow you to configure details about the different objects to be cut and engraved, and also allow you to control the laser directly.

The Layer Section gives you options for each 'layer' in your project. Layers …